ArubaWiFi: (04) Hướng dẫn Register thiết bị Aruba 135 tới Controller 3400

By , 0 View

Mục tiêu thực hành:
- Tiến hành Convert Aruba 135 sang chế độ "Campus APs managed by a Mobility Controller".
- Quan sát tiến trình khởi động của Aruba 135 trong suốt quá trình Convert sang chế độ Campus AP.
- Kiểm tra trạng thái Register của Aruba 135 tại giao diện WebPage của Controller 3400.

Các bước triển khai:
Tiến hành Convert Aruba 135 sang chế độ "Campus APs managed by a Mobility Controller".

Quan sát tiến trình khởi động của Aruba 135 trong suốt quá trình Convert sang chế độ Campus AP.
Sending SIGKILL to all processes.
Please stand by while rebooting the system.
Restarting system.

APBoot 1.2.8.1 (build 34939)
Built: 2012-08-17 at 12:54:18

Model: AP-13x
CPU:   88F6560 Z2 (DDR3)
Clock: CPU 1600MHz, L2 533MHz, SysClock 533MHz, TClock 200MHz
DRAM:  256MB 
POST1: passed
Flash: 16 MB
Power: DC
LAN:   done
PHY:   done
PEX 0: RC, link up, x1
       bus.dev fn venID devID class  rev    MBAR0    MBAR1    MBAR2    MBAR3
       00.00   00  11ab  6560 00005   01 f1000000 00000000 00000000 00000000
       00.01   00  168c  0030 00002   01 90000000 00000000 00000000 00000000
PEX 1: RC, link up, x1
       bus.dev fn venID devID class  rev    MBAR0    MBAR1    MBAR2    MBAR3
       01.00   00  11ab  6500 00005   01 f1000000 00000000 00000000 00000000
       01.01   00  168c  0030 00002   01 94000000 00000000 00000000 00000000
Net:   eth0, eth1
Radio: ar9390#0, ar9390#1

Hit <Enter> to stop autoboot:  0 
Booting OS partition 0
Checking image @ 0xf6100000
Copying image from 0xf6100000

Image is signed; verifying checksum... passed
Signer Cert OK
Policy Cert OK
RSA signature verified. 
## Booting image at 02000200 ...
Uncompressing... done

Aruba Networks
ArubaOS Version 6.4.4.9 (build 55980 / label #55980) 
Built by p4build@lemnos on 2016-08-04 at 11:06:51 PDT (gcc version 4.3.3)
Memory: 256MB = 256MB total
Memory: 243584KB available (2844K code, 9042K data, 4060K init, 0K highmem)
Delay calibration in progress:
Calibrating delay loop... 1597.44 BogoMIPS (lpj=1597440)
khelper used greatest stack depth: 15160 bytes left
khelper used greatest stack depth: 14836 bytes left
PEX0 interface detected Link X1
PEX1 interface detected Link X1
bio: create slab <bio-0> at 0
wdt: registered with refresh
Enabling Watchdog
Kprobe smoke test started
Kprobe smoke test passed successfully
cryptomgr_test used greatest stack depth: 14780 bytes left
cryptomgr_test used greatest stack depth: 14728 bytes left
cryptomgr_test used greatest stack depth: 13944 bytes left
Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253)
serial8250_probe: pdata: c06e71a0
Registered port at index 0 (IO0 MEMf1012100 IRQ34): 0
i2c /dev entries driver
i2c-arran: using default base 0xf1018180

Starting Kernel SHA1 KAT ...Completed Kernel SHA1 KAT 
Starting Kernel HMAC-SHA1 KAT ...Completed Kernel HMAC-SHA1 KAT 
Starting Kernel DES KAT ...Completed Kernel DES KAT 
Starting Kernel AES KAT ...Completed Kernel AES KAT 

Starting Kernel AESGCM KAT ...
cryptomgr_test used greatest stack depth: 13452 bytes left
Completed Kernel AESGCM KAT 
AP-type has_ble_support: .
Domain Name: arubanetworks.com
No panic info available
init mv_cesa ok
Ethernet port 1 mode: active-standby
Ethernet Channel Bonding Driver: v3.5.0 (November 4, 2008)
eth0: link up, full duplex, speed 1 Gbps
ADDRCONF(NETDEV_UP): bond0: link is not ready
eth0: link up, full duplex, speed 1 Gbps
bonding: bond0: making interface eth0 the new active one.
bonding: bond0: first active interface up!
bonding: bond0: enslaving eth0 as an active interface with an up link.
ADDRCONF(NETDEV_CHANGE): bond0: link becomes ready
eth1: link down
bonding: bond0: enslaving eth1 as a backup interface with a down link.
AP xml model 51, num_radios 2 (jiffies 5165)
init_asap_mod: installation:0
radio 0: band 1 ant 0 max_ssid 16
radio 1: band 0 ant 0 max_ssid 16
ethernet_device_event: dev eth0 is up
eth0: link up, full duplex, speed 1 Gbps
eth0: link up, full duplex, speed 1 Gbps
Starting watchdog process...
Getting an IP address...
192.168.100.158 255.255.255.0 192.168.100.254
Running ADP...Done. Master is 192.168.100.234
ath_hal: 0.9.17.1 (AR5416, AR9380, REGOPS_FUNC, PRIVATE_DIAG, WRITE_EEPROM, 11D)
ath_rate_atheros: Copyright (c) 2001-2005 Atheros Communications, Inc, All Rights Reserved
ath_rate_atheros: Aruba Networks Rate Control Algorithm
ath_dfs: Version 2.0.0
Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved
ath_spectrum: Version 2.0.0
Copyright (c) 2005-2006 Atheros Communications, Inc. All Rights Reserved
ath_dev: Copyright (c) 2001-2007 Atheros Communications, Inc, All Rights Reserved
ath_pci: 0.9.4.5 (Atheros/multi-bss)
ath_attach: scn cd4d0320 sc cd280000 ah cd2c0000
wifi0: Base BSSID d8:c7:c8:81:56:70, 16 available BSSID(s)
eth0 address=d8:c7:c8:c0:15:66
br0 address=d8:c7:c8:c0:15:66
wifi0: AP type AP-135, radio 0, max_bssids 16
wifi0: Atheros 9380: mem=0xf3000000, irq=25 hw_base=0xd1dc0000
ath_attach: scn cc8d0320 sc cc8e0000 ah cc900000
wifi1: Base BSSID d8:c7:c8:81:56:60, 16 available BSSID(s)
eth0 address=d8:c7:c8:c0:15:66
br0 address=d8:c7:c8:c0:15:66
wifi1: AP type AP-135, radio 1, max_bssids 16
wifi1: Atheros 9380: mem=0xf4000000, irq=24 hw_base=0xd1f40000
ath_ahb: 0.9.4.5 (Atheros/multi-bss)
ath_ahb: No devices found, driver not installed.
 
Starting FIPS KAT ... Completed FIPS KAT

AP rebooted Wed Nov 10 10:12:41 UTC 2021; Image Upgrade Successful
shutting down watchdog process (nanny will restart it)...
 
        <<<<<       Welcome to the Access Point     >>>>>
 
~ # 

~ # ping 192.168.100.234
PING 192.168.100.234 (192.168.100.234): 56 data bytes
64 bytes from 192.168.100.234: icmp_seq=0 ttl=64 time=2.3 ms
64 bytes from 192.168.100.234: icmp_seq=1 ttl=64 time=0.8 ms
64 bytes from 192.168.100.234: icmp_seq=2 ttl=64 time=1.7 ms
64 bytes from 192.168.100.234: icmp_seq=3 ttl=64 time=0.6 ms
^C
--- 192.168.100.234 ping statistics ---
4 packets transmitted, 4 packets received, 0% packet loss
round-trip min/avg/max = 0.6/1.3/2.3 ms

~ # 

Kiểm tra trạng thái Register của Aruba 135 tại giao diện WebPage của Controller 3400.

Tham khảo các video Khóa học Wireless Controller để nắm cơ chế hoạt động của công nghệ Controller, mọi thắc mắc các bạn vui lòng liên hệ với mình thông qua kênh Zalo (Jade Bùi) 076.877.2021.

You Might Also Like

0 comments